Infrared Heating for Swiss Hotels
Silent. Dustless. Designer finishes. Individual room control. The SunWave Ceramica delivers the thermal comfort guests expect — with zero noise and zero maintenance, room by room.
Request a Hotel QuoteWhy Guests Notice the Difference
Infrared heating is perceived differently from convective heating — guests feel warmer at lower air temperatures, notice no noise, no dust, and no dry-air discomfort.
Completely silent
No fan, no pump, no thermostat click. The SunWave Ceramica operates in total silence. Guests sleeping light in mountain chalets and city hotels notice the absence of mechanical noise — especially during the night setback cycle when conventional heating systems click on and off.
No dust circulation
Convective heaters and fan coil units circulate air and with it, dust, allergens, and particles. Infrared heating does not move air. Room occupants with dust sensitivity, hay fever, or asthma experience noticeably cleaner air. Fraunhofer WKI measured TVOC emissions of just 0.043 mg/m³ — far below regulatory limits, with no carcinogenic compounds detected.
Instant warmth — no wait time
Infrared radiation warms surfaces and occupants directly, within seconds of the panel starting. There is no "warm-up" period waiting for hot water to circulate or air to heat. Guests entering a cold room feel warmth immediately — even before the air temperature has fully recovered.
Comfortable humidity levels
Convective heating dries the air, leading to the parched-throat feeling guests associate with hotel rooms. Infrared heating warms surfaces without significantly affecting relative humidity. Guests consistently report more comfortable air quality in infrared-heated rooms.
The SunWave Ceramica is available in nine porcelain finishes designed to complement Swiss hotel interiors — from clean alpine whites to warm stone and contemporary slate. A selection is shown below.
All finishes available in the same 60×120 cm panel size. Mix finishes across room types or maintain consistency throughout the property.
Room-by-Room Control
What a Property-Wide Installation Looks Like
Infrared works well as a room-by-room or wing-by-wing retrofit — install in occupied areas first, and expand as budgets allow. Here's what a typical mid-size property looks like.
Example: 20-Room Property
- Zero maintenance cost — no service contracts, ever
- 0.043 mg/m³ TVOC — independently tested by Fraunhofer WKI
- Heat only occupied rooms — switch off or to frost-protection when empty
- Plug-in or hardwired — fits room-by-room retrofits without disrupting other guests
- Nine porcelain finishes — match any interior style
- 5-year warranty per panel
Upgrade your guests' comfort. Reduce your heating bill.
We'll provide a room-by-room plan, panel count, and capital cost for your specific property.
Request a Hotel Quote